Our website uses cookies
Cookies are small files held on your computer which allow us to give you the best browsing experience possible. You can delete and block cookies but parts of our site will not work without them. By using our website you accept our use of cookies.
I’m happy with thisFind out more
Milanese Prime Oak Unfinished Wood Flooring brand
+ Rollover images to enlarge

Milanese Prime Oak Unfinished Wood Flooring

SKU: 1346

metres per pack: 1.810

Under 30m² £44.87
30m² + £42.37
60m² + £39.88
90m² + £38.46
Pack Qty:
£81.21 per pack (Exc. Vat)
Price Calculator
Area

Wastage allowance

0% 20%
CALCULATE PRICE

phone Need advice? 0845 6021 781 Alternative: 01379 642843 | Out of hours: 07568 077907
fb tt pin gp

• Prime Grade Unfinished Oak Floor
• Oak single pank with 4mm top layer
• 190mm wide, 20mm thick, 1900mm long
• Select/prime grade oak
• Tongue and groove to four sides, 1.805m2 pack, bevelled 2 sides
The Milanese oak flooring range is a charming selection of key colour stained and natural finished 21mm engineered oak floor boards. Milanese prime grade is specially selected at the mill to offer a nice clean oak floor with little colour variation and consistency of character.
The unfinished Milanese range has been chosen for its consistency of finish and unrivalled standard of milling. This makes the Milanese range not only easy maintenance but also a very durable surface ready for your choice of finish. Source Wood Floors strongly recommends using either the Osmo hardwax selection of colours and natural oils or the Bona range of lacquers.
The Milanese range of boards offer a substantial 6mm top layer of oak in a beautifully machined plank comprising a high quality base layer, resulting in a multiply construction that gives superior strength and dimensional stability. It comes in a 1.805 sq m pack.
Using the Source Wood Floors 'floor calculator' along with our revolutionary wastage estimator you are sure to get the correct amount for your project. If you are unsure of anything please do not hesitate to contact one of the Source Team members who will always be more than happy to help.

board constructionmulti-ply
board thickness20mm 
character gradeprime
edge stylebevel
floor finishUnfinished
floor typeengineered plank
profiletongue and groove 4 sides
shadelight-natural
speciesoak
surface texturesmooth
top layer4 mm

Our 21mm engineered boards are ideal for secret nailing or installation by the full stick down, they can be floated on an underlay but the previously mentioned are Source Wood Floors preferred methods of installation. 

Installation with the Sika professional wood flooring glue is recommended and ideal for use with underfloor heating installations.

Carefully examine the flooring for colour, finish and quality before installing it. Use reasonable selectivity and hold out or cut off pieces with glaring defects whatever the cause. If the flooring is not acceptable, contact Source Wood Floors immediately. 

Before beginning installation of any hardwood flooring product, the fitter must determine that the environment of the job site and the condition and type of the subfloor involved are acceptable, ensuring that it meets or exceeds all requirements which are stipulated in the Source Wood Floors fitting instructions. 

Source Wood Floors declines any responsibility for job failure resulting from or associated with inappropriate or improperly prepared subfloor or job site environment deficiencies. When ordering hardwood flooring allow for a 5% to 10% wastage allowance depending on layout which must be added to the total square meterage. This will endure only the boards the owner deems fit will end up being fitted.