Our website uses cookies
Cookies are small files held on your computer which allow us to give you the best browsing experience possible. You can delete and block cookies but parts of our site will not work without them. By using our website you accept our use of cookies.
I’m happy with thisFind out more
Milanese Prime Grade Oak Lacquered Hardwood Floor brand
+ Rollover images to enlarge

Milanese Prime Grade Oak Lacquered Hardwood Floor

SKU: 20

metres per pack: 1.810

Under 30m² £49.85
30m² + £47.36
60m² + £46.86
90m² + £45.87
Pack Qty:
£90.23 per pack (Exc. Vat)
Price Calculator

Wastage allowance

0% 20%

phone Need advice? 0845 6021 781 Alternative: 01379 642843 | Out of hours: 07568 077907
fb tt pin gp

• Oak single plank with 6mm top layer
• Prime/select grade
• Lacquered with a matt finish
• Tongue and groove on 4 sides and 1.805m2 per pack
• 20/4 x 190 x 1900mm

The Milanese oak flooring range is a charming selection of key colour stained and natural finished 20mm engineered oak floor boards. Milanese prime grade is specially selected at the mill to offer a contemporary prime grade floor with little colour variation and a max knot size smaller than a 5p piece.
The prime lacquered board in the Milanese range has been chosen for its consistency of finish and unrivalled standard of milling. The lacquered finish gives the wood a beautiful matt finish bringing out the wonderful consistency in the grain.  The lacquered finish makes this Milanese board not only easy maintenance but also a hard wearing surface. Source Wood Floors recommends the use of the Bona maintenance products to keep your floor looking like new.
The Milanese range of boards offer a substantial 6mm top layer of oak in a beautifully machined plank comprising a high quality base layer, resulting in a multiply construction that gives superior strength and dimensional stability. It comes in a 1.805 sq m pack.
Using the Source Wood Floors 'floor calculator' along with our revolutionary wastage estimator you are sure to get the correct amount for your project. If you are unsure of anything please do not hesitate to contact one of the Source team members who will always be more than happy to help.

board constructionmulti-ply
board thickness20mm
character gradeselect
edge stylebevel
floor finishMatt Lacquered
floor typeengineered plank
installation methodglue or float
profiletongue and groove 4 sides
surface texturesmooth
top layer4 mm

Our 20mm engineered boards are ideal for secret nailing or installation by the full stick down, they can be floated on an underlay but the previously mentioned are Source Wood Floors preferred methods of installation. 

Installation with a professional Sika wood floor adhesive is recommended and ideal for use with underfloor heating installations.

Carefully examine the flooring for colour, finish and quality before installing it. Use reasonable selectivity and hold out or cut off pieces with glaring defects whatever the cause. If the flooring is not acceptable, contact Source Wood Floors immediately. 

Before beginning installation of any hardwood flooring product, the fitter must determine that the environment of the job site and the condition and type of the subfloor involved are acceptable, ensuring that it meets or exceeds all requirements which are stipulated in the Source Wood Floors fitting instructions. 

Source Wood Floors declines any responsibility for job failure resulting from or associated with inappropriate or improperly prepared subfloor or job site environment deficiencies. When ordering hardwood flooring allow for a 5% to 10% wastage allowance depending on layout which must be added to the total square meterage. This will endure only the boards the owner deems fit will end up being fitted.