• Single plank oak engineered
• Rustic Grade
• Top layer of oak 6mm
• Board dimensions 20 x 190 x 1900mm
• Tongue and groove to 4 sides and 1.805m2 pack size
The Campania oak flooring range is a charming selection of key natural finished and unfinished 20mm engineered oak floor boards. Campania unfinished boards
are specially selected at the mill to offer a nice clean oak floor with good
colour variation and consistency of nice character.
Campania range has been chosen for its level of finish and unrivalled standard
of milling. This makes the Campania range not only easy to finish but also a
very durable surface ready for your choice of oil or lacquer. Source Wood
Floors strongly recommends using either the Osmo hardwax selection of colours or
natural oils or the Bona range of lacquers.
Campania range of boards offer a substantial 6mm top layer of oak in a
beautifully machined plank comprising a high quality base layer, resulting in a
multiply construction that gives superior strength and dimensional stability.
It comes in a 1.805 sq m pack.
Source Wood 'floor calculator' along with our revolutionary wastage estimator
you are sure to get the correct amount for your project. If you are unsure of
anything please do not hesitate to contact one of the Source Team members
who will always be more than happy to help.
|board thickness||20mm |
|floor type||engineered plank|
|profile||tongue and groove 4 sides|
|top layer||6 mm|
Our 21mm engineered boards are ideal for secret nailing or installation by
the full stick down, they can be floated on an underlay but the previously
mentioned are Source Wood’s preferred methods of installation.
Installation with the Sika professional wood flooring glue is recommended
and ideal for use with underfloor heating installations.
Carefully examine the flooring for colour, finish and quality before
installing it. Use reasonable selectivity and hold out or cut off pieces with
glaring defects whatever the cause. If the flooring is not acceptable, contact Source Wood Floors immediately.
Before beginning installation of any hardwood flooring product, the fitter
must determine that the environment of the job site and the condition and type
of the subfloor involved are acceptable, ensuring that it meets or exceeds all
requirements which are stipulated in the Source Wood Floors fitting
Source Wood Floors declines any responsibility for job failure resulting from or
associated with inappropriate or improperly prepared subfloor or job site
environment deficiencies. When hardwood flooring is ordered, a 5 %
allowance factor, depending on layout, must be added to the actual square
footage amount needed, this will endure only the boards the owner deems fit
will end up being fitted.